Butterfly Grip Kit
8X8 Butterfly Kit #5 (group A only)
- (1) 8x8 Frame
- (4) 48’’ Round tubes with corner connectors
- (2) 48’’ Round tubes with straight connectors
- (2) 48’’ Round tubes with baby pin adapters
- (1) Solid
- (1) 8x8 Ultrabounce
- (1) 8x8 Unbleached Muslin
- (1) 8x8 Silk
- (1) 8x8 Half Grid
8x8 Frame (Round Tubes)
8x8 Cloths
Assembling the 8X8 Butterfly Kit #5 (group A only)
Assemble the kit by laying all the pieces on the ground, painted sides facing up. In the corners, there are pins, which should be facing up. These two pieces are painted black.
-
This kit uses push-button connectors; press the blue button in the center to lock or unlock them.
The completed frame with the baby pins pointing outward.
Before attaching the rags, put the frame in the stand. The ropes around the edges only need to be tied for exteriors; use a standard shoelace knot.
When storing the frame, gather the corner pieces and place the corners (the heavy part) in the case at the end with the wheels.
8X8 Butterfly Kit #4 (group B only)
- (1) 8x8 Frame
- (4) 48’’ Square Tubes with corner connectors
- (2) 48’’ Square Tubes with straight connectors
- (2) 48’’ Square Tubes with baby pin adapters
- (2) 4 ½” Griphead ears
- (1) Allen Wrench
- (1) 8x8 Ultrabounce
- (1) 8x8 Bleached Muslin
- (1) 8x8 Silk
- (1) 8x8 Half Grid
8x8 Frame (Square Tubes)
8x8 Cloths
Assembling the 8x8 Butterfly Kit #4 (group B only)
The kit contains 8 square 4' tubes that connect to form a frame; then you will stretch and tie the rag over the frame. Thumb screws on the connections allow for quick assembly.
In the standard setup, baby pins are on opposite sides of the frame. Before attaching the rags, put the frame in the overhead stand. The ropes around the edges only need to be tied for exteriors; use a standard shoelace knot.
The accessories in the bag allow you to switch from the baby pin to a set of ears. The ear setup is more secure and is recommended for exterior shooting. Use the Allen wrench to remove the baby pins.
Insert and tighten the straight connectors.
The ear slides over the square frame and locks into place with a thumb screw. The ear should be at a right angle to the frame.
Loosen the grip head and drop the ear into place.
When storing, place the corners (the heavy part) in the case at the end with the wheels.
