[659] Ronin Kit

Documentation for the Ronin Kit and Intelligent Battery Safety Guidelines

Ronin Kit 

TOP LEVEL

(1) Hand Grip Upper

(1) Hand Grip Lower

(1) Quad Charging Hub

(1) Dual TB50- Battery Mount 

(1) Universal Mount 

(1) Top Mounting Block

(1) Ronin Multitool

(1) Ronin Black Accessories Package 

(1) Top handle Clip w/ Easyrig Knob

(1) Plastic Bag for the little lens support piece you don’t want to lose

(3) BNC Cables (Red, Black, Thin)

(1) Ronin universal baseplate with SmallRig Manfrotto clip-in mount

(2) mounting screws

(1) Ronin Camera top Mount

(1) Ronin Accessory mount

(1) Cold Shoe Mount with 1 screw
(1) Small Rig ball monitor mount with Nato clamp

LOWER LEVEL

(1) Ronin Gimbal

(4) TB-50 Batteries
(1) Remote controller

Counterweights 

(1) 200G Weights

(2) ¼”-20 to rail thread adapters

(1) Power supply for quad charger

(1) Power cord for quad charger

Intelligent Battery Safety Guidelines

Battery Use

  • DO NOT allow the batteries to come into contact with any kind of liquid. DO NOT leave batteries out in the rain or near a source of moisture. DO NOT drop the battery into water. If the inside of the battery comes into contact with water, chemical decomposition may occur, potentially resulting in the battery catching on fire, and may even lead to an explosion.
  • DO NOT use the battery in strong electrostatic or electromagnetic environments.
    Otherwise, the battery control board may malfunction.

Battery Charging

  • DO NOT attach the batteries to wall outlets or car charger sockets directly, and always use a DJI approved adapter. DJI takes no responsibility if the battery is charged using a non-DJI charger.
  • Never leave the battery unattended during charging. DO NOT charge the battery near flammable materials or on flammable surfaces such as carpet or wood.
  • DO NOT charge battery immediately after use, because the battery temperature may be too high. DO NOT charge the battery until it cools down to near room temperature. Charging the battery outside of the temperature range of 41° F to 104° F(5° C to 40° C) may lead to leakage, overheating, or battery damage.
  • Disconnect the charger when not in use. Examine the charger regularly for damage to the cord, plug, enclosure, or other parts. DO NOT clean the charger with denatured alcohol or other flammable solvents. Never use a damaged charger.
  • The Intelligent Battery is designed to stop charging when it is full. However it is a good practice to monitor the charging progress and disconnect the batteries when fully charged.

Battery Storage

  • DO NOT leave the battery near heat sources such as a furnace or heater. DO NOT leave
    the batteries inside of a vehicle on hot days. The ideal storage temperature is 72° F to 82° F (22° C to 28° C).
  • DO NOT store the battery with fully discharged for a long time, otherwise it will over discharge and lead to a permanent damage.
  • Discharge the battery to 40%-65% if it will NOT be used for 10 days or more. This can greatly extend the battery life. The battery automatically discharges to below 65% when it is idle for more than 10 days to prevent it from swelling. It takes approximately 3 days to discharge the battery to 65%. It is normal that you may feel moderate heat emitting from the battery during the discharge process.
  • The battery will enter hibernation mode if depleted and stored for a long period. Recharge the battery to bring it out of hibernation.
  • Remove batteries from the gimbal when stored for an extended period.

Battery Maintenance

  • Never use the battery when the temperature is too high or too low.
  • Never over-discharge, as this may lead to battery cell damage.
  • Battery life may be reduced if not used for a long time.
  • Discharge and charge the battery completely once every three months to keep it in good condition.



Keywords:
gimbal, ronin, 659, camera support, battery, DJI 
Doc ID:
124689
Owned by:
Peter S. in CommArts IMC
Created:
2023-03-09
Updated:
2025-02-21
Sites:
CommArts Instructional Media Center