Performing Inspections
1. Login to the GO Work Management app.
2. Tap on the arrow next to the Phase that you want to perform the inspection on.
3. Tap on the blue Inspection number to enter the inspection for this Phase.
4. Enter your GO Asset Management credentials (they are the same as your Work Management credentials), then tap Login.
5. Tap on the arrow next to the top Line Item to start the inspection.
6. Review the task, and if it is marked as Required, then tap on Value.
Note: You must record a Value on all Required Line Items in the Inspection.
7. Tap on the selection that conforms to that Line Item’s requirement. In this example, we were asked to review the Job Hazard Analysis, and we did, so we select YES.
8. Tap on the arrow next to Result.
9. Tap the Result type that conforms to the result of this Inspection.
10. Tap Next to save the results of this Line Item and move onto the next Line Item in the Inspection.
11. If the Line Item is not marked as Required, tap on the arrow next to Result.
12. Tap the Result type that conforms to the result of this Inspection. If the result is a Fail then tap Yes to add remedial actions.
13. Tap on the desired remedial action, then tap Save.
14. Tap on the arrow next to Photo Gallery to add photographs to this Line Item.
15. You may take new photographs or add ones from your Photo Library.
16. If the Result is Fail, tap on Value to add a note about the issue found.
17. Tap anywhere in the large grey box in the middle of the screen to start typing.
18. Type or dictate your note describing the reason for the Fail Result for this Line Item. Then tap Done.
19. Tap Next to save the results of this Line Item and move onto the next Line Item in the Inspection.
20. As you proceed through each Line Item, you can add notes (Value) and photos (Photo Gallery) to Line Items as you see fit, no matter the status of the Result.
21. Once you are done with the last Line Item, tap Done, then tap Yes when prompted to submit the inspection.
22. If you are taken back to the Inspection screen, tap on the arrows next to any Line Items with a blue dot and mark a Result of Pass, Fail, or Not Applicable as appropriate for that Line Item.
23. If you are at the Inspection screen and see no blue dots, then tap the Submit button to finish the Inspection and submit it.
24. Once the Inspection is finished, add additional information (Notes and Documents), record the time you spent working (Time), and complete the Phase (Status).