How to setup the barcode scanners for the Librarians
Barcode setup for the new USB Scanners is very simple:
1. Plug in the Barcode scanner via USB.
2. Find the "codabar" settings in the setup book or print off the picture below. (Last book it was chapter 5, page 20.)
3. Scan the "codabar enable" bar code.
4. Scan the "Do Not Send Start/Stop" barcode
This causes the bar code scanner to scan the numbers in the code, but ignore the beginning B and the last A characters of the code.
If the attached image below does not print correctly, all documentation for the scanners can be found at: http://www.waspbarcode.com/support/onlinedocs.asp