ResNet Router Configuration Specifications

A brief list of the configuration specifications for a wireless router to work correctly on ResNet.

This document operates under two assumptions with your router.
1. You have access to the router setup page or application for your respective router. This will be included within your router's documentation.
2. Your router has been registered on to ResNet. Please view this document for assistance with router registration.

To make the process of configuring your router easier, it may be better to simply factory reset your router and then set it up again. The instructions for going about this will also be included with your router's documentation. Otherwise, feel free to alter your router's configuration from its current configuration or simply run the configuration wizard/setup process to obtain these settings.

Note that your router may have differing setting and this document is just covering the general settings it should have. Any setting not mentioned below is inconsequential to successful internet connection on ResNet.

 Internet Connection Type/WAN Connection Type
 Automatic configuration DHCP
 Connection Sharing/Operation Mode
 Share a public IP address
 DHCP Server
 Enabled
 DDNS  Disabled
 MAC Address Cloning
 Disabled
Wireless Network Mode/Radio Mode
 Mixed/Automatic
Wireless Security
WPA2-Personal
Remote Management
Disabled






Keywords:resnet, router, network, wireless, setup, ip, address, admin, registration, housing   Doc ID:35490
Owner:Mike C.Group:UW Housing
Created:2013-11-26 16:53 CDTUpdated:2016-06-17 09:15 CDT
Sites:DoIT Help Desk, DoIT Tech Store, UW Housing
Feedback:  1   0